精雕机厂家

News

Product

keywords

Contact

Company:Shenzhen Yadis Electronic Technology Co.,Ltd

Contacts:13728719739 Mr Hu

             18665897736 Mr Li

Tel:0755-81499136

Fax:0755-29875493

Web:www.szyadis.com

Adds:3 / f, building B1, junfeng industrial zone, no.176, chongqing road, fuyong town, bao 'an district, shenzhen

What are the methods to reduce the noise of five-axis precision carving machine?

Your current location: Home >> News >> Knowledge

What are the methods to reduce the noise of five-axis precision carving machine?

Date of release:2018-07-19 Author: Click:

                 We usually use five axis carved machine at the same time, will hear the sound of the roll, the voice is in addition to the five axis carved machine produced by the body in the process of running equipment some sound, engraving equipment will be issued under a certain frequency carving some obvious noise, and the noise of the original was much higher than the sound produced by the body equipment. In some cases, this noise will affect the use of equipment, so it needs to be dealt with in a timely manner; But sometimes the sound is normal, there is no way to improve it, so we have to distinguish what is noise when we deal with noise. Today we're going to talk about ways to reduce the noise of five-axis precision carving machines:

五轴精雕机

 

             The five-axis precision carving machine can perform non-contact cutting and punching for metal or non-metal sheet and pipe. Problems of noise generated during processing of five-axis precision carving machine:

             First five - axis precision carving machine to a certain direction when walking in the direction of noise. For example, the fine engraving machine can only have noise when walking left and right. Otherwise, it is normal when running up and down or back. Then there must be something wrong with the bearing of X-axis motor.

            Then the machine will produce noise when the main shaft of the five-axis precision carving machine rotates, while the machine will be normal when it does not rotate. It must be the bearing of the main shaft or the spindle itself has a problem. The poor quality of the spindle bearing or the use of the spindle for too long may lead to such problems, and when encountering problems, please think and summarize, these problems are relatively easy to solve.

             Finally, there is some noise, which is not very consistent, but the machined parts are relatively stable and not affected. This situation is generally the normal condition of the fine engraving machine with stepping motor, because the stepping motor itself will produce certain noise when it works, but it will not affect the machining accuracy and stability of the five-axis fine engraving machine. In fact, if the ac servo motor is replaced, the noise will be basically eliminated, the processing speed and precision of the machine can be greatly improved, of course, the cost will also be increased.


The address of this article:http://en.szyadis.com/news/405.html

Key word:五轴精雕机,首饰精雕机,精雕机厂家

Recently browse:

  • Service
  • number
    18270919270
  • Message
  • web site
  • Online Service
    Please leave a message for us
    Please input the message here, and we will contact you as soon as possible.
    name
    Contacts
    Telephone
    Telephone
    mailbox
    mailbox
    address
    address